Installation Hardware is Included.
The CAST-IN-PLACE EZ Set Tile is molded from an incredibly strong and durable polymer concrete. Its stainless steel anchoring system and quick installation make it the preferred tile for new construction and installation in wet concrete.
EASY - Simple one-person installation in less than 10 minutes with no special equipment.
STRONG - Unique molded polymer-concrete tile is slip resistant and provides years of strong, durable service.
Detectable Warning Systems - CAST IN PLACE EZ Set Tile™
REPLACEABLE - Tamper-resistant stainless steel anchoring system provides solid installation, yet allows for fast replacement should the need arise.
DESIGN - The EZ Set Tile is available in the "in-line" or square pattern as recommended in the PROWAAC Final Report. The 2.35" inline spacing of the domes in a square pattern and beveled edges allow for improved access by wheelchair users.
Install the 5/16" stainless steel anchor bolts into the preformed holes from the topside of the tile and hand tighten the anchor devices snug on the bolts to the bottom of the tile.
Trace an outline where tiles are to be placed in the wet concrete. This can be done using the point of a trowel or by making a wooden template. Be certain that the placement meets the specifications and drawings for the job.
Set the first tile in place at one end of the traced outline and press into the wet concrete using a wiggling motion. Be careful not to push the tiles too far into the concrete. The edge of the tile should be even and level with the surrounding concrete. Place the second tile next to the first leaving a 1/4" gap and using the same wiggling motion to press it into the wet concrete. Be certain that the second tile is even and level with the first and with the surrounding concrete.
Trowel concrete flat, remove any excess concrete and verify there is a 1/4" gap between the tiles. Apply broom finish or other recommended finish to the area immediately surrounding the tiles.
Recheck the slope using the electronic level, and adjust the tiles if necessary to maintain the required slope specifications.
The final step of the process is to sponge or brush the surface to remove any excess concrete that may have been left on the surface of the EZ Set tiles. Do not allow any pressure from walking or other sources to be applied to the EZ Set tiles during the concrete curing process (two days minimum).
ADA Products 
